The pumps ZP6000 are used for direct lubrication in multi-line systems (one delivery element per lubricating point) or as delivery pump for lubricant in progressive systems.
- Multi-line pump
- up to 32 lubrication points
- Pressure range up to 160 bar
- Lubricant: oil, grease, liquid grease
- Surface signal grey RAL 7004
Drive of pump ZP6000 is effected by means of electromotor with step-down gearing flanged onto the housing and linked with the worm shaft via Woodruff key in form-fit connection. Each feed-line connection is equipped with a delivery piston and a control piston. A rotary motion is imparted on the pump shaft with cam disk via drive, vertical shaft and bevelgear pair the delivery piston getting a stroke motion. The control gear is to actuate the control piston. Due to the stroke motion of delivery pistons, lubricant intake is effected through the control ducts of control pistons and delived into the pressure bore. The scraper plate is delivering the lubricant to the suction bores. The stirrer blade pressing the lubricant through the sieve plate into the suction compartment is arranged in the lubricant reservoir. The pump ZP6000 can be supplied with 1 or 2 pumping units installed opposite to each other with a maximum of 16 feed-line connections. The rate of delivery can be set infinitely from 0 ... 0,2 cm³/stroke. Upon dispatch of pumps, the rate of delivery has been set to maximum value. Feed-line connections not required shall be out to “zero rate of delivery” and should not be closed.